Blower hopper equipped for chips
Blower door with two turbines operating in parallel. One brings the air through a
venturi system, the other was designed to suck the shavings into a suction box in the center of the door.
This turbine is powered by a 156mm diameter worm screw, pitch 150, pitch
to the left and not to the right, to bring the chips back to the center of the turbine.
The mixing of chips and air takes place inside the suction box, and in the outlet cone by the venturi of the air turbine.
This blower is driven by a Hydro Leduc M25 or M32 motor, it also has a 315cc hydraulic motor for the auger.
The unloading speed is adjustable by a hydraulic regulator.
The propulsion pipes are 150mm in diameter.
Integrated blower between two doors with external control (increased noise reduction efficiency and improved aesthetics)
Training | Flat blowing | Flow rate ( M3/MIN ) | Configuration |
32-41cc HYD. REQUIREMENTS ≥ 120 L/MIN | > 40 | 0.6 < > 1.0 | On dumpster door (noise hood) |
POWER TAKE-OFF TRACTOR | > 40 | 0.6 < > 1.0 | Double door finish (CMD EXT.) |
